1. Disconnect a wire from the negative plug of the rechargeable battery.

Fig. 7.2. Measurement of a carving part of a tip of a cable of coupling: 1 – carving part of a tip of a cable of coupling; 2 – clip; 3 – the separating lever

Measure length of a carving part of a tip of a cable acting from the separating lever and write down value (see fig. 7.2).

Fig. 7.3. Elements of fastening of a cable of coupling to the separating lever: 1 – carving part of a tip of a cable of coupling; 2 – clip; 3 – nut

2. Remove a clip 1 (see fig. 7.3), turn off a nut 3 and disconnect a carving tip of a cable of coupling from the separating lever.

3. Remove a coupling pedal as follows:

Fig. 7.4. Elements of fastening of a pedal of coupling: 1 – nut; 2 – spring clamp; 3 – axis; 4 – washer; 5 – returnable spring

– disconnect a returnable spring 5 (see fig. 7.4) from an arm;

– remove a spring clamp 2;

– turn off a nut 1;

– remove a washer 4;

– remove axis 3;

– remove a pedal.

Fig. 7.5. An arrangement of a returnable spring (2) and a cable (3) on a pedal of coupling (1)

4. Remove a returnable spring 2 (see fig. 7.5) and a cable of coupling 3 from a pedal of coupling 1.

Fig. 7.1. Coupling elements: 1 – the separating lever; 2 – clip; 3 – nut; 4 – coupling cable; 5 – pro-masonry ring; 6 – washer; 7 – spring clamp; 8 – nut; 9 – washer; 10 – arm; 11 – axis; 12 – returnable spring; 13 – overlay of a pedal; 14 – coupling pedal; 15 – sealing ring; 16 – epiploon of a main shaft of the transmission; 17 – coupling cover; 18 – bolt; 19 – the directing basic plug; 20 – coupling switching off bearing; 21 – coupling switching off fork; 22 – plug; 23 – washer; 24 – bolt; 25 – the conducted clutch plate; 26 – press clutch plate; 27 – washer; 28 – bolt; 29 – bolt

1. Establish a cable of coupling 4 (see fig. 7.1) and a returnable spring 12 on a pedal of coupling 14.

2. Establish a pedal of coupling 14 on an arm 10.

3. Grease an axis of a pedal of coupling with jellied lubricant and establish it as follows:

– establish an axis through an arm 10 and a pedal 14;

– establish a washer 9;

– screw a nut 8;

– establish a spring clamp 7;

– establish a returnable spring 12 on an arm 10.

5. Install a coupling cable on the separating lever.

6. Screw a nut on a carving part of a tip of a cable of coupling on the same distance at which it was before removal.

7. Adjust a coupling cable.

8. Establish a clip 2.

9. Connect a wire to the negative plug of the rechargeable battery.